How to Die Cut 2" Finished Triangles in Square:
For best cutting results, position fabric on the lengthwise grain (straight of grain) as it goes under the roller.
- Center Triangle: Cut a 3 1/4" strip across the width of fabric. Fanfold into 3" widths. Place on selected blade and cut. Cut 13 triangles in square-center triangles across the width of fabric. One yard of 40" wide fabric cuts 143 triangles in square-center triangles.
- Side Triangles: Cut a 2 3/4" strip across the width of fabric. Fanfold into 3" widths. Place on selected blade and cut. Cut 26 triangles in square-side triangles across the width of fabric. One yard of 40" wide fabric cuts 338 triangles in square-side triangles.
Why Quilters Love the GO! Triangles in Square-2" Finished Square Die:
- The GO! Triangles in Square die makes it a snap to cut perfect center triangles and half rectangle side triangles that piece together to form a 2" finished square. Create star points in blocks, borders and more with this die.
- The GO! Triangles in Square-2" Finished Square die is the perfect size to cut your own triangles with your favorite fabrics or out of fabric pieces from your stash.
- GO! Triangles in Square-2" Finished Square includes 1/4" seam allowances and dog-eared corners for easy alignment and piecing.
- Cut Triangles in Square out of a variety of fabrics: cotton, batiks, wool, felt, flannel, fleece, Cuddle® fabrics and more!
- A great way to use up scraps.
- Free pattern downloads available to get you started.
- Charm Pack-friendly.
- Cut so much more fabric in less time.
- Get accurate cuts every time -- No slipping rulers or mistakes
- Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
- Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut.
- Safe to use -- No blades come anywhere near your fingers
- With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors.
- Blades on some dies are positioned at an angle. Align fabric to edge of shape, not edge of die board.
- Use good quality fabric to reduce fabric stretch.
- It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.